| Specifications: |
| Instrument |
|
Measuring Range |
Oxygen Content: 0-200%; resolution 1%
Temperature: 5-80°C; resolution 1% |
Temperature compensation |
Automatic 5-80°C in connection with the built-in temperature probe in the sensor |
Calibration method |
Air calibration |
Data Storage |
Memory for approx. 3,200 data sets |
Interface |
RS-232 for configuration and data read-out |
| Display |
LCD 2 lines, 7mm |
| Power supply |
Battery 9V, IEC 6 F22 |
| Ambient Temperature |
-10-55°C |
| EMC |
Accordance EN 61326 class B; EMC standard 89/336/EWG |
| Housing |
Protection IP 65; dimensions 200mm x 90mm x 40mm (LxWxL) |
| Weight |
Approx. 0.260kg (with battery) |
Software programme 'AM 39'
functions
|
Configuration and read out of the data logging system
Calibration functions for air calibration and by comparison measurement
|
| Sensor |
|
| Measuring Range |
Oxygen content: 0 - 0.3bar oxygen partial pressure
Temperature: 5-80°C |
| Operating temperature |
5-80°C |
| Air humidity |
Max. 100% relative air humidity but no condensation on the sensor |
| Response time t90 |
Oxygen: Approx. 250s at 25°C for change between ambient air to nitrogen
Temperature: Approx. 14 minutes at 25°C (sensor in stick-in housing) |
| Dimensions |
Shaft lengths 120mm; shaft diameter 18mm |
| Temperature sensor |
Platinum resistor Pt 1000 |
| Admissible overpressure |
Max. 1 bar above atmospheric |
| Measuring position |
30° or up to 45° from vertical |
| Material |
FEP, stainless steel 1.4571, POM |
| Connection cable |
Fixed multi-wire screened cable 2.5m with plug (special cable length upon request) |
| Oxygen / Temperature Stick-in Housing |
| Material |
Stainless steel WS 1.4571 (DIN 17440) |
| Operating temperature |
0 - 80°C |
| Dimensions |
ø 22mm (shaft), approx. 28mm (tip), total length about 1100mm |
| Weight |
about 2.5kg |
| Electrical connection |
Fixed cable from oxygen sensor |
| Due to Enviroequips' continuous programme of improvement, this specification is subject to change without prior notice |
