 |
| _ |
|
|
Designed to be used
in the field, Clor-N-Oil is a fast, accurate method to test electrical insulating fluids
for the presence of PCB. Each pocket-sized kit contains everything necessary to perform
the test in less than 5 minutes. All premeasured reagents are sealed in glass ampules for
safe, fast, consistent and accurate results. Screening transformer oil with Clor-N-Oil can
eliminate non-PCB fluids from costly laboratory analysis and allows a greater number of
samples to be tested at less cost.
Clor-N-Oil is available for testing transformer oil at four different action levels; 20
ppm, 50 ppm, 100 ppm and 500 ppm. To eliminate the possibility of false negatives, Dexsil
calibrates all Clor-N-Oil test kits on Aroclor 1242. Aroclor 1242 contains the least
amount of chlorine (42% by weight) of the Aroclors found in electrical insulating fluids.
By calibrating our test kits using Aroclor 1242, the user obtains the most conservative
results. When Clor-N-Oil test kits turn purple, you can be assured your oil sample is
below the action level.
Specifications |
| Analytes |
PCB as chloride |
| Matrix |
Transformer Oil |
| Detection
Method |
Fixed endpoint
colorimetric titration |
| Action
Level |
Above or Below 20,
50, 100 or 500 ppm |
| Analysis
Time |
Less than five
minutes |
| Official
Method |
US EPA SW-846 Method
9079 |
|
| Ordering Information |
| CL-020 |
Clor-n-Oil 20 |
| CL-050 |
Clor-n-Oil 50 |
| CL-100 |
Clor-n-Oil 100 |
| CL-500 |
Clor-n-Oil 500 |
|
Minimum order 20
kits |
|
